Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:AC Blower problem
From:John Goubeaux
Date:Sun, 20 Jul 2008 12:23:39 -0700

Thanks Mark,

You "nailed it"       It is not so easy to see that a "bare metal strip"
is in fact the fuse when it is no longer there. Bentley shows a fuse but
it was not clear based on the fuzzy images what to look for.

I confirmed that (after making the connection that the fuse provides)
the blower works in the 2 high settings just fine !!

So the obvious question now is:    Where to get a replacement fuse ?
This has to be a dealer item ??

-john

mdrillock wrote:
> The 2 higher speeds run off a separate fuse from the 2 lower speeds.
> This fuse also powers the compressor clutch and the radiator fan low
> speed when A/C is on. This fuse is very important obviously.
>
> The fuse in question lives inside the lh rear pillar cover. It is really
> a bare metal strip screwed at each end to the base of a relay holder in
> that area. The metal strip is the fuse. That immediate area is prone to
> cooked wires so look at it carefully even if the fuse is good. Use a
> voltmeter to check the fuse and the wires.
>
> Mark
>
> John Goubeaux wrote:
>> Folks,
>>
>> I have a situation on a 90 (with factory AC)   where the AC fan works on
>> the first two settings but nothing on the 3rd and 4th. I have already
>> trbl shot the switch up fwd and it IS good.
>>
>> So is this a problem with the evaporator fan resistors ?  or someone
>> suggested that:
>>
>> "There are two fan resistors, one for each fan motor. Unless they both
>> burned out at the same time, they are probably not your problem, its
>> more likely you have a problem with the evaporator fan switch and its
>> associated wiring."
>>
>> I'm not sure if this is referring to the wiring back in the lh rear and
>> if both resistors burned out would the fans run at all?
>>
>> The compressor is not working (yet) so I can't actually "fire the system
>> up" properly and I'm not sure if this is the source of only two speeds
>> either.
>>
>> Can anyone with knowledge of how the system works steer me in the right
>> direction?  What am I missing?
>>
>> Many thanks ....
>>
>> -john
>>
>>