I did this with the rear section of a Vanagon so that I could mock up
engine conversions.� The floor was cut right where the rear of the
sliding door would be and a radiator mounted there.�� Tracks
quite well.� Really if I were to do this, I would use a single cab
bed.� 

This will be used for my up coming body lift
project as it is easier to turn this upside down and attach all the bits
that way than monkeying with a van in the garage and trial fitting
something one hundred times.

David Marshall
 
http://www.hasenwerk.ca
Box 4153, Quesnel BC, Canada V2J 3J

On Sat, August 2, 2008 20:50, Matthew wrote:
> I was out
getting firewood today and got to thinking about a trailer. Has
>
anybody seen a vanagon chopped into a trailer? I know of a good vanagon
> shell at a junk yard... it would then match my single cab :-)
> 
> I'd have to cut the rear hatch and hinge it to work as a
tailgate, and the
> weld the door closed... like the Duke Boys.
But i think it can be done.
> 
> ideas?
> matt
> 
> "may the four winds blow you safely home"
> 
> 
> 
>