Hi Craig,

I made a paper template using graph paper and copied the original hole
location. I located the template by measuring to the fore and aft seams and
creased the template where it meets the folds in the body, measuring up to
the roof as well just below it to be able to locate it on the other van.
Measure 20X, cut but once.

Then I just used a jig-saw to cut through the template.

Have a look here:
http://www.flickr.com/photos/jetstar5224/725530174/in/set-72157600658016311/

Glad to hear it's coming together!

Dave

(Headed to BOTC)

On Fri, Aug 8, 2008 at 6:16 AM, craig cowan <phishman068@gmail.com> wrote:

> I'm at the point where i will son be cutting the hole for the fridge flu,
> and wondering "How they did that"?
> I was always under the impression it was a round hole.......it is however,
> far from it. So what's the best method of cutting it accurately?
> It's probably too thick for tin snips, a sawzaw would be too rough, a
> series
> of hole saws could get you close, there must be a trick.
>
> What have people done!?!?
>
> -Craig
> '85GL (Half Westy)
> '80Westy (Half rust)
>
> <Snip>