

| Subject: | Re: Seeking Mark "Dr. Wires" Drillock |
| From: | mdrillock |
| Date: | Tue, 19 Aug 2008 18:48:54 -0700 |
Plug 6 is for the 2 oil pressure switches. On waterboxers with 2 switches there are 2 brown wires, one from each switch, that go to the same 2 pin connector. Plug 6 goes to that connector. Plug 7 looks to me like the Temp 2 sensor wires. Not certain but VW uses matching blue plastic housings on both the sensor and the plug for it. Mark Chris S wrote: > Could you please identify the following for me? I think these are the > final two plugs. > > Plug 6 - Yellow (high oil pressure?) & black/blue > > http://i16.photobucket.com/albums/b7/misterpolak/WBX_transplant/Example_Pics/Plug6.jpg > > Plug 7 - Blue/red & gray > > http://i16.photobucket.com/albums/b7/misterpolak/WBX_transplant/Example_Pics/Plug7.jpg > > > > On Sun, Aug 17, 2008 at 10:15 AM, mdrillock <mdrillock@cox.net > <mailto:mdrillock@cox.net>> wrote: > > Plug 1, yellow/red & brown, coolant temp sensor for gauge > > Plug 2 , red/white & brown/green, to fuel pump > > > Plug 3 , white/green, A/C compressor-on signal to idle speedup > circuit. > > Plugs 5, power steering pressure switch to idle speedup circuit. > > Yellow wire, oil pressure switch, higher pressure switch of 2 > switches. > > > Mark > > > > Chris S wrote: > > But really, if I was 100% sure, would I be asking you? HELP! > I hope I'm in > the last stages of sorting out my mystery harness and this > should enable me > to finally start her up. > > 1. Nice little plug - what do you think it's for? > > http://i16.photobucket.com/albums/b7/misterpolak/WBX_transplant/Example_Pics/Plug1.jpg > > 2. and this one? > > http://i16.photobucket.com/albums/b7/misterpolak/WBX_transplant/Example_Pics/Plug2.jpg > > 3. Ok... something easier for a change - what's that > green/white one? > > http://i16.photobucket.com/albums/b7/misterpolak/WBX_transplant/Example_Pics/Plug3.jpg > > 4. A hint.. these are near the alternator > > http://i16.photobucket.com/albums/b7/misterpolak/WBX_transplant/Example_Pics/Plug5.jpg > > 5. > http://www.subaruvanagon.com/tom/Getting%20Started/Black%20box%20stock%20sm.jpg > > 2.1L WBX - The round engine plug to the engine harness has a > large central > yellow wire. What is it for? > > > > > > > > > > > > -- > Chris S. > "Jeszcze Polska Nie Zginęła" > >
Have something to add on this topic today? Revive this thread in the forum »