I have two version 1 DigiTools available for sale with the ECU prewired.
pmail me if interested.

dylan

----- Original Message ----
From: mdrillock <mdrillock@COX.NET>
To: vanagon@GERRY.VANAGON.COM
Sent: Thursday, September 11, 2008 10:09:26 PM
Subject: Re: Question about temp II sensor and bad running

Jim, I just purchased an extra Digitool on Ebay and it came yesterday.
Today I tested it on my 87 daily driver. I am willing to send it to you
for diagnostic purposes. It comes with a spare ECU that has the required
extra 25 pin connector for the Digitool to hook up to. Vanagon 2.1
Digifant only.

This is the original version 1.0, built by Daryll Boehler

http://www.loam.org/vw/Vanagon/DigiTool/

Mark

Jim Felder wrote:
> I'm not sure I did the test right. Scott said something about leaving
> the sensor in the system and testing it. That's not what I did. I got
> the pipe hot by running the car and set the multimeter on 2 volts and
> probed the contacts. I am not sure that should yield anything or not.
>
> Jim
>
> On Thu, Sep 11, 2008 at 4:32 PM, mdrillock <mdrillock@cox.net> wrote:
>
>> Zero volts shows a bad sensor, assuming proper measurement setup.
>>
>> Replacing the o2 sensor is the logical step now. Then you need to wonder if
>> some underlying problem will kill the replacement as well.
>>
>> Mark
>>
>>
>>
>> Jim Felder wrote:
>>
>>> ..........
>>> Well, for a few bucks, one of the listmembers is going to sell me a
>>> tested O2 sensor and for that kind of money I will know for sure. Plus
>>> it doesn't hurt to have a spare O2 around even if mine is working.
>>>
>>> I started the car and let it get hot. I put my digital multimeter on 2
>>> volts and checked the terminals. It read 0.00.
>>>
>>> Jim
>>>
>>>
>>
>>
>
>
>