On Wed, Sep 24, 2008 at 10:39 PM, David Marshall
<mailinglist@fastforward.ca> wrote:
> If you have sealed beams now, you don't need electrical adapters.
>
> For aiming I use the European 2% dip, so find a flat parking lot with a
> building next to it - bricks or something with siding works we as you have
> a horizontal reference point.
>
> Park your van so it is 10m away
> from the wall.  Measure distance from the center of the lights to the
> ground and then measure where the "cut off" is on the wall - it
> should be 2% lower.  10m is 1000cm and 2% of 1000 is 20, so 20cm
> lower than the center of your lights.  Other than that - make sure
> they are the same distance apart and of course going straight ahead.
>
> David Marshall

Good advice! The New Zealand authorities insist that the lights must
be inclined much lower than this (about 15-20 degrees) and be adjusted
off to the left!! Assholes. Pardon my Swahili.

I park some distance (about 10m indeed) behind a parked sedan on the
road and adjust my lights until the low-beam cutoff is JUST below the
car's rear window, and pointing dead ahead. This passes official
6-monthly tests and I don't get oncoming drivers flashing their
high-beams at me.

If you're in Fiji, it doesn't matter where the lights are pointing, as
long as it's not ahead or just below level.