To all,

The vendor, Van-Again, was very quick and courteous with his reply and, it turns out, that the problem was mine, not his.

I made the mistake of thinking that Ken's kit was identical to the kit Frank Condelli sells, but that's not correct.  Unfortunately, I used Frank's instructions, which calls for a longer return hose, but I had Ken's hose...well...in my hand (oh man, that sounds SO wrong...)

So the moral is this:  be sure that you use the vendor-supplied instructions and accept no substitutes.  Hopefully this thread hasn't caused any confusion.  And pay attention as to whose hose you're playing with.

Cecil

-------------- Original message --------------
From: Dan Winget <william.winget@VERIZON.NET>

> I purchased and installed the Kit Ken sells( Vanagain) I did not have
> any trouble at all
>
> Dan
>
> On Tue, Sep 30, 2008 at 7:17 PM, Mike Collum wrote:
>
> > Cecil Eastman wrote:
> > check the length of the low-pressure hose before beginning.
>
> Strange.� Some time ago, I replaced my steel lines with Frank's kit.� I
> didn't measure before beginning, but both hoses were just the right
> length.
>
> Mike
> Houlton, ME/Glade Spring, VA