The $2.87 syringe of Devcon Plastic welder works for this as well if
you don't want to drop the big bucks on the West systems stuff.  I
keep the West epoxy because I do a lot of composite repairs.  Adding
powdered tempra paint(HObby Lobby etc) will turn non-black adhesive
black as well and actually add a little thickening.  Corn starch
works too, as does baby powder(calcium carbonate) or graphite powder
from Gougeon.  Depends on what properties you're looking
for.  Chopped up fiberglass strands would be stonger for sure.

DM&FS

At 11:48 PM 10/12/2008, JordanVw@AOL.COM wrote:
>In a message dated 10/12/08 9:50:22 PM Eastern Daylight Time,
>becida@COMCAST.NET writes:
>
>
> > My map pocket has most of the plastic pieces where the screws hold
> > the pocket to the drivers door broken. Has anyone else repaired this
> > before? Searching didn't help me.
> >
> > Right now I'm thinking of JB Weld type stuff formed into the needed
> > repair areas and dried. Then drill them so I can put the screws back into
> > it.
> >
> >
>
>yup..  JB weld does it..  i run the screws into beeswax then put the screws
>into the JB weld.   that way the screws dont stick to the JB weld and can be
>removed.
>
>chris
>
>
>**************
>New MapQuest Local shows what's happening at your
>destination.  Dining, Movies, Events, News & more. Try it out
>(http://local.mapquest.com/?ncid=emlcntnew00000002)