Volks:
  Bentley 13.38 says that I can change out my 2.1L rubber engine mounts
with the engine still in the bus.  Do I remember correctly from the
engine swap that the best way to get at the mounts is to:

  1. support the engine with a floor jack,

  2. unbolt the carrier bar from the bus,

  3. lower the engine slightly,

  4. unbolt the two bolts holding the support bracket to the block,

  5. and then unbolt the four rubber mounting blocks from the bracket?

  Much obliged for any guidance.

Best,
d.
1990 GL -- "Mudskipper"