Are you referring to the exhaust and inlet pipes for the burner, or the
heat ducting? The stainless flex pipes for the burner can make some
fairly tight bends, however the heater should be mounted on the floor or
sidewall so that the pipes exit the interior in a short distance as
possible; from there they can bend.

Karl

M'obeechi wrote:
> I have the larger Propex. My challenge is that I need to install it
> on the passenger side, under the rear seat, but no further from the
> passenger side than those two factory holes meant for the stock rear
> heater coolant lines. Those vent hoses the Propex came with are large
> enough that turning a sharp corner or turn, doesn't look possible. So
> maybe this means I have to have something fabricated, or else maybe
> these is some product out there that I'm not aware of that allows for
> venting hoses through tighter turns.

------------------------------------------------------------
+    To unsubscribe from the Vanagon List send an e-mail to
+    listserv@gerry.vanagon.com with SIGNOFF VANAGON
+    in the body of the message.
------------------------------------------------------------