Well, it's been a long time since I've looked into it, but I just touched my
test probe against the end of one of the broken pressure switch wires and
saw voltage--which I thought was definitely strange.  I see your point and
it now makes sense.  It's given me no problems since.  Apparently this is a
common failure point with the wiring harness.

On Sun, Dec 14, 2008 at 2:57 PM, Mike Collum <collum@verizon.net> wrote:

> BTW, if you disconnect any ground wire from a working circuit then put a
> meter between the lifted ground wire and a good grounding point, you'll see
> voltage.  A ground wire is simply the other side of a circuit (circuit
> implying circle).  That's why good grounds are just as important as good
> positive wires and connections.
>
> Mike
>
>

--
Casey
'87 300TD
'94 100CSQ Avant
'89 Bluestar

------------------------------------------------------------
+    To unsubscribe from the Vanagon List send an e-mail to
+    listserv@gerry.vanagon.com with SIGNOFF VANAGON
+    in the body of the message.
------------------------------------------------------------