I'm not going to attempt to use those holes. Too easy to just block off effectively and besides, they are so much bigger than needed for the size of the intake/exhaust hoses for my Carver (pretty much same set up as Propex) that I'd rather just drill holes convenient to the installation location, as you say, on the psgr side, under the bench. Drill attachment hole-cutting tools are inexpensive and easy to use.

Bob Stevens
'87 Syncro Westy
My challenge is that I need to install it on the
> passenger side, under the rear seat, but no further from the passenger side than
> those two factory holes meant for the stock rear heater coolant lines. Those
> vent hoses the Propex came with are large enough that turning a sharp corner or
> turn, doesn't look possible. So maybe this means I have to have something
> fabricated, or else maybe these is some product out there that I'm not aware of
> that allows for venting hoses through tighter turns.

------------------------------------------------------------
+    To unsubscribe from the Vanagon List send an e-mail to
+    listserv@gerry.vanagon.com with SIGNOFF VANAGON
+    in the body of the message.
------------------------------------------------------------