

| Subject: | Re: 85 vanagon throttle body swap... top mounted vs bottom mounted TPS ???? |
| From: | Scott Daniel - Turbovans |
| Date: | Sat, 28 Feb 2009 17:20:37 -0800 |
since it's an auto trans vanagon I would be sure to check the lever and throttle cable at the side of the transmission. The throttle cable ends in a ball pivot on the trans lever. I have seen that ball pivot be very rusty, even stuck. point is........you want to be sure it's not at the trans......whatever binding or drag you are experiencing. I haven't see a throttle body to that actually, bind so much from wear that it wouldn't return to zero throttle. ----- Original Message ----- From: "Mike Collum" <collum@MYFAIRPOINT.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Saturday, February 28, 2009 11:42 AM Subject: Re: 85 vanagon throttle body swap... top mounted vs bottom mounted TPS ???? > Oh, one other thing, the vacuum hose arrangement is different from early > to late 1.9s. One of the throttle bodies doesn't have the vacuum tube. > You just have to route the vacuum lines accordingly (see the Bentley). > > Mike > > > > Mike Collum wrote: >> The switch, on the later model 1.9s (closes at both idle and at full >> throttle), does the same job as the two switches on the earlier 1.9s. >> Either TB can be used if you modify the harness to accept the other >> connector(s). >> >> Mike >> >> >> >> Greg Potts wrote: >>> Hi Volks, >>> >>> I checked the archives but have not seen a complete answer to this >>> question. ETKA diagrams don't seem to answer it either. >>> >>> My Dad's 1985 automatic sunroof vanagon has been having problems with >>> the throttle linkage. Apparently the problem is at the throttle body. >>> This morning it hung up at high RPMS and would not dislodge until the >>> engine lid was lifted and the lever reset by hand. Once it was reset, >>> everything was fine. I suspect that the brass butterfly is rubbing >>> against the aluminum casing and the friction has become enough to >>> overcome the tension of the return spring. >>> >>> I have a spare 1.9L engine with a throttle body that is in very good >>> condition. Unfortunately, the TB on the sunroof van has the throttle >>> position switches underneath, and this TB has the TPS located on top. >>> >>> BEFORE we pull it all apart... is it possible/practical to swap these >>> units, or should we plan to repair the original TB instead? >>> >>> Happy Trails, >>> >>> Greg Potts >>> 1973/74/79 Westfakia "Bob the Tomato" >>> 1987 Wolfsburg Weekender Hardtop >>> www.busesofthecorn.com >>> www.pottsfamily.ca >>> >>> >>> >>
Have something to add on this topic today? Revive this thread in the forum »