I had the same issue with my high beem indicator light.  Swaped out the
buld with a new one and still did not work.  I was puzzeled so I tested
the bulbs for continuity and they both were good. I ended up tracking the
problem down to the bad conection in the block that hold the bulb.  I
carefully pulled off the block to investigate and found that the pin from
the circiut board was bent (for some reason) and did not properly contact
one of the bulb pins.  Streightened it out and put the block back on
and...I saw the light.

Pascal
'84 Westy

On Wed, 11 Mar 2009 10:46:55 -0300, Jack R. <jack007@comcast.net> wrote:

> Rob,
>
> It is likely the circuit board, or something in that area, as the bulb
> seldom burns out.
>
> Ask how I know... well, I searched high and low (no pun intended) and
> located the proper bulb (verified working, thank you Jonce!), replaced it
> and still no indicator in my 84 Westy.
>
>
> If anyone else on the list has had a similar issue... please let us know
> how
> you resolved it!