Devcon Plastic Welder(PERMATEX has similar).  Check "active"
ingredients for   Methyl Methacrolate.  Different than the syringe
epoxies, and bonding strength is like 3000# after a 24 hour
cure.  Sets up in 5 minutes at 70 degrees F.  Stinks while curing,
but you'll get over it.  Best part; one syringe should do your job
and have plenty left over.  Less than $3 a tube unless you have to go
to Ace or Tru Value to get it.  Wal Mart usually sells one of the brands.

Good luck

DM&FS

At 01:59 PM 3/26/2009, neil N wrote:
>On Thu, Mar 26, 2009 at 11:45 AM, Rob <becida@comcast.net> wrote:
> > It's time to try and fix my '84 Vanagon grill, the lower grill has a
> > couple of broken slats and I have the slats.
> > Any recommendations on glue that works well for this type of plastic?
> >
> >
> >
> > Rob
> >
> > becida@comcast.net
> > Western Washington State, USA
> >
>
>
>I used that Goop stuff to repair cracks and breaks. Held up fine.
>
>Neil.
>
>--
>Neil Nicholson '81 VanaJetta 2.0 "Jaco"
>
>http://tubaneil.googlepages.com/
>
>http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines