Thanks Gerry, 

I just picked up some PC7 epoxy paste, has anybody ever tried to THIN this stuff?

It says it wont run or sag, I NEED it to run down into the seam of the tank. 

Doug

  ----- Original Message ----- 
  From: vanagonstretch@aol.com 
  To: vanagon@ASTOUND.NET ; vanagon@GERRY.VANAGON.COM 
  Sent: Saturday, April 25, 2009 7:01 AM
  Subject: Re: gas fuel tank sealant repair needed

  I used JB Weld on my gas tank and it's been holding perfectly. Just make sure it's very clean before application.

  Cheers, Gerry
  www.vanalong.com

  ---- Original Message ----
  From: Doug Noganav <vanagon@ASTOUND.NET>
  To: vanagon@GERRY.VANAGON.COM
  Sent: Fri, 24 Apr 2009 9:56 pm
  Subject: gas fuel tank sealant repair needed

This is not directly for a fuel tank its for a parts washer tank which holds 
solvent. The bottom seam of the barrel is leaking at the seam where its crimped. 

There is a large grove in on the inside that can be filled. 

Thinking permatex, RTV, ? Epoxy?

Any suggestions?

Thanks,

Doug

------------------------------------------------------------------------------
  AOL Sessions - Watch in studio exclusive video performances from today's top artists.