

| Subject: | Re: 87 2.1 loss power |
| From: | Amy Miner |
| Date: | Thu, 18 Jun 2009 16:20:46 -0400 |
Yes I did check the braid itself to ground and yes its grounded. The center wire is clean until I turn the key on and I get .5 volts. I put one lead on the braid and one test lead on the block and I get an almost solid short. Where does this braid get its ground from? ie..where is the ground point for it? I did notice a small brown ground wire coming off the computer and I cleaned that up when doing my inital assesment...Thanks for the help so far. Please keep it coming. A. On Thu, Jun 18, 2009 at 4:11 PM, mark drillock <mdrillock@cox.net> wrote: > But did you check that the braid itself is grounded to the block? It must > be grounded for the O2 system to work. > > The center wire must never be grounded and the braid must always be > grounded. > > Mark > > > Amy Miner wrote: > >> What concerns me is that when the motor is fully warmed up and I touch the >> center which had .5 volts on it to ground nothing changes. I did check the >> wire and there is no ground on it with a ohm meter. I checked to ground on >> the block and checked to the braid around the coax and there is no short >> to >> ground. The injectors have all been pro cleaned before I installed them. I >> tried to pull plug wires at idle and each one changes the way the motor >> runs >> very little. I have a fuel pressure gauge and I will check that tonight. >> At >> idle is appears to run okay but when I rev the motor I get puffs of black >> soot. Even leaves little black specs on the ground. I am just trying to >> figure out what would make the motor get "stuck" in what appears to be a >> cold running mode. Would to much fuel make the van lose power while >> driving? >> I also checked the oil and it still looks/smells clean. Doesn't appear to >> have fuel in it. I'll report back on the fuel pressure later,I'll check >> all >> grounds again,pull the plugs and look at them. >> Will look back here for more suggestions when I get home before I start >> working on it tonight >> so please keep the suggestions coming. I'd like to get this sorted out >> before my husband gets home from work this weekend. >> >> A. >> >
Have something to add on this topic today? Revive this thread in the forum »