Aha!  My next "Project"...Re-clean the orfice and check the valve to make
sure it is also clear.

  Also on my agenda is another attempt at fixing my Odo, which just crapped
out again today, after my winter-time fix.  This time on the odo I have all
my tools and a controlled enviornment.  Trying to fix that odo while on
extended stay in the winter time desert was a bit frustrating....sand, wind,
cold and no tools.
  Don Hanson

On Sun, Jul 26, 2009 at 7:27 PM, David Beierl <dbeierl@attglobal.net> wrote:

> At 10:10 PM 7/26/2009, craig cowan wrote:
>
>> How does one adjust the gas velocity?
>> I've cleaned the  orifice.
>>
>
> That's how.  If the flame is too lean it can lift off the burner
> tube, just as with a stove burner.  On a stove you can adjust the air
> flap, but here the orifice and the gas inlet pressure are the only
> variables.  Mmmm...there's an internal filter in the gas valve, I
> believe, that could get clogged.
>
>
>  --
> David Beierl - Providence RI USA -- http://pws.prserv.net/synergy/Vanagon/
> '89 Po' White Star "Scamp"
>