That's how I do it - run the hose in the window, get all the junk in the
compartment out of the way, fill the tank from the top.

The thing is, it's good to have another person at the faucet on the hose, so
you can ask them to turn it off when your tank is getting full.  Otherwise
you have to pull out the hose while it's running and toss it very quickly
out the window.

Joy

On Thu, Aug 27, 2009 at 3:40 PM, Tom Buese <tombuese@comcast.net> wrote:

> To avoid the possible leaking into the van syndrome, it is easy to
> fill the tank from inside by removing the 3-4" diameter tank cap &
> placing the hose in the tank directly at any volume till it's full &
> then turning off the hose before it overflows?  It takes more time to
> access the tank, but the filling is much faster, you can see how much
> water you are putting in, the condition of the tank, pump, hoses etc.
> & you get to bond w/ your storage tank & related equipment while
> sitting inside?
>
> YMMV,
>
> Mr. BZ
>
>
>
>
>
> On Aug 27, 2009, at 11:56 AM, Troy wrote:
>
>  <<How do you get the tank to fill rapidly, even with a rapid flow
>> rate?  I
>> have to keep the flow rate very low, or water fills the filler tube
>> and
>> overflows.  It takes a long while for me to fill the tank, being
>> careful
>> to avoid overflows due to backup as I go.>>
>>
>> That was going to be my question as well! A person would think that
>> I have a 100 gallon tank inside the van with the amount of time it
>> takes to fill that small 13 gallon tank. I've always had to keep the
>> flow down to a slow trickle, although at times I thought about
>> removing the screen to speed the process.  Since the tube doubles as
>> a vent, the water would probably come gushing back if filled too
>> rapidly. The solution would be to add a vent, but it would have to
>> terminate higher than the fill valve to avoid a leak, at least
>> that's my theroy;)
>>
>> Troy
>>
>