Good call John,
I pmailed the same thing to Z.
I have seen that a few different times.
Once, the van was run anyway and the disc fell apart jamming up the works and not allowing any clutch travel.
If this is the fact, make sure to check flywheel surface carefully for scoring.

dylan.

________________________________
From: John Morris <mongrelcat@WINDSTREAM.NET>
To: vanagon@GERRY.VANAGON.COM
Sent: Sunday, September 27, 2009 10:14:45 AM
Subject: Re: Clutch pedal won't go to floor

Placing the clutch disk in backwards may cause this symptom.

John in NC

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Zoltan
Sent: Saturday, September 26, 2009 3:23 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Clutch pedal won't go to floor

Hi to all,
As you see on the headline, the pedal won't go to the floor.� This is not my
van.� I't an '88 van, the guy just changed the transmission and the clutch.
Maybe he has done something in the assembly process that causing this.� I
don't know, I never seen this happen.� The slave is good, the pedal starts
engaging high enough but it stops about two inches before the floor.
Anyone?
Zoltan