At 08:24 AM 9/28/2009, TJ Hemrick wrote...
>  I'm not getting any fuel out of the injectors but definitely have
> good
>clean fuel in the lines.  I had some help and found the injectors were
>getting voltage but it's incredibly low.  It peaks at 4 volts and
>within two
>revolutions, it holds at 2-3 volts max.

If you're just using a simple multimeter to measure the voltage, that
sounds correct. The injectors are pulsed, so even if they get full
voltage when pulsed on, the meter will average the voltage down. You
would need an oscilloscope to see the actual drive voltage.

Pull the injectors on one side, and check the spray pattern.