re
"Rick told me they no longer have them'

no longer have injectors, or clamps ?
I'm not near the east coast, but I but I have lots of good used injectors
and fuel rails, if that is what you seek.

you don't say the condition of the hose where it's clamped onto the fuel
rail.
Perhaps it's squished and old there.
Or if the hose clamps are the kind with a tiny screw in them.....
the clamp could just be 'bottomed out' and not able to squeeze any tighter.
but I have lots of good used injectors if that is what you seek.

the oxygen sensor is on the left side of the engine.
Sounds like you are describing # 3, the left forward injector, or near
there.
Scott
www.turbovans.com
----- Original Message -----
From: "Robert Stewart" <robertmstewart@MAC.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Monday, September 28, 2009 11:09 AM
Subject: Looking for a good fuel injector rail- East Coast preffered

> Hi everyone,
>
> So after my rebuilt engine went in, drove it for 400 miles I realized
> that my injector rail on the right side of the engine (on the side
> where the 02 sensor is) was leaking.
>
> It is leaking from the injector that is closest to the back seat.
>
> Now these were the original rails on the van and I never had an issue
> with them before. I am not sure if my mechanic over tightened the
> clamp down when he put the injectors on the rail or what but I am
> definitely noticing a small amount of fuel seeping out of the area
> near the bottom of clamp on the rail.
>
> I called Bus Depot but Rick told me they no longer have them. Called
> GoWesty and neither to do they. Nor do they have any kind of custom
> replacement in development.
>
> So does anyone on the east coast have a good one for me?
>
> Thanks,
> Robert
> Bloomingburg NY