I get it now. The wire from the pulley sensor gets a female end. The wire
from the pushrod sensor gets a male end. I guess you don't have the original
wires and connector.

The cut wires you show by the license plate go to the other license plate
light (there's two wired separately).

Always at your service, brother.

Time for me to get back in the garage and keep taking my motor apart. I'm
getting in pretty deep.

On Tue, Oct 13, 2009 at 6:51 AM, Jeff Lincoln <magikvw@gmail.com> wrote:

> That's the thing Roger - the wires to the sensors themselves are not hooked
> to anything the wires on the connector int he picture lead back to the
> wiring harness.
>
> I have the straight connector witht he rubber boot already on the sensor by
> the push rod tubes but I am not sure where to connect the wire end - I'll
> have to make a wire connector for the sensor behind the pulley - I just need
> to know where it connects up top.
>
> I'm fairly sure this is where those things hook up but I want to be sure.
>
> On Tue, Oct 13, 2009 at 6:14 AM, Roger VanTill <motelvw@gmail.com> wrote:
>
>> Jeff, check the ends of the sensor wires. On my motor the one behind the
>> pulley has a 90 degree female end. The one under the pushrod tubes is
>> straight with a rubber boot. I'll look for those other wires when it's
>> light
>> out.
>>
>>
>>
> --
> Thanks,
>
> Jeff
> '90 Carat (Grover)
> '86 (We call this one Parts)
> '78 Bus (Melissa) Patty's Bus
>