David,
I don't have the belts you want but I am just bought a set to install in
my van. Actually only going to install the one behind pass as I have a
Westy. I followed what another list member did and welded a small
section of tubing to a small flat 1"wide by 2" long steel. If you don't
have a welder or access to one I have seen what another Vanagon
owner did. He used a two large allen bolts and then bolted them to the
floor.
He then drilled the head out to accept the legs on the bottom of the seat.
He said he got the bolts at the local hardware store. It provided a very
rugged mounting point.

Bill

On Tue, Nov 3, 2009 at 3:07 PM, David Cohen <Mtbdavid2@aol.com> wrote:

> Hi,
>  I picked up some nice wolfsburg jump seats last night with male side  of
> the seat belts but missing the female wire side of the seatbelts which
> mount
>  in the center walkway up front.  Does anyone have a set they want to
> sell?
>
> Also, any creative suggestions on making my own floor mounts for these jump
>  seats?  I have the rear brackets for the seats but need to make my own
> floor brackets.  Any help would be appreciated.  These are going in my
>  1990
> Vanagon GL.
>
> Next project after this is a rebuilt tranny and clutch kit.  My  current
> tranny has the 3rd gear syncro going out and grinds in and out of third
>  gear.
>  I will be looking for one to buy next month.  I was hoping they  had a 5
> spd that mounted to the 2.1 WBX motor.
>
> David
>