Hi all -

In attempting to clean my ground wires on the engine block, I busted the
head off the bolt holding them in place.  So what next?  Should I just
attempt to ground them some where else on the block?  If so, any good
candidates?  I see that the A/C compressor is bolted to the block nearby.  I
could go for one of those.  Or should I attempt to extract the offending
bolt with an e-z-out and replace?  I don't have a lot of clearance, so the
e-z-out route might be difficult.

Thanks for any insights!

Mark

--
Mark
1990 Westy (2.1 - manual)