Miguel,

I certainly see your concern - and I could really be wrong on my next point
- but it makes sense to me that as long as it's dry when you install it -
and you are sure there aren't any pockets of air underneath (use a roller) -
then moisture shouldn't be too much of an issue.

Also, the stuff is made for roof repair - so moisture from the outside
shouldn't mee too much of a problem either - over lap the seams a bit thugh.

Again I could be wrong about that. You are correct though once on this stuff
would be a major pain to remove.

I think what I'll do is try to pull some off when I am parting out Grover
and see just how hard it is - then I'll let you all know.

--
Thanks,

Jeff
'85 GL (Gertie)
'90 Carat (Grover - the noble parts donor)
'86 (We call this one Scrap)
'78 Bus (Melissa) Patty's Bus