At 12:44 PM 4/9/2010, Scott Chapman wrote:
>I read that the copper pipes to the propane tank are 8mm?
>
>In that case, I'm wondering if one of these would be any use in flaring
>the pipe after I cut off a couple inches to make it work with the new
>regulator on the new tank?

Dear Scott,
For cutting the tool of choice would be a tubing cutter, likely a
midget one for close-quarters use.  You roll it around the tube while
gradually advancing a hard thin swaging disk into the tube, which
soon parts off leaving a large burr on the inside to be reamed out.

8 mm is very close to 5/16 inch.  Since this is a US tank with a US
regulator and US refrigerator (and stove?) I would expect the
plumbing to be US standard as well.

Yours,
David