On Fri, Apr 9, 2010 at 8:28 PM, Alan Felder <dieseldoofus@gmail.com> wrote:

> I am helping a friend install an AHU in his 82d westy. �Swapped tranny for
> an air cooled (DK?) and re-mounted orig bell housing. �He purchased and
> installed the port side replacement engine mount to clear below the stock
> turbo. �I believe he used the DK nose mount on the tranny.
>
> Engine/Tranny is now installed. �Seems to me to sit about an inch higher
> than it should. �Also we had to stretch that nose mount maybe 3/8 inch to
> get it to bolt in.
>
> any thoughts on this? �I don't see a way to lower the engine, is there an
> adjustment for that?. �Also, should we unbolt the nose mount and turn the
> mount plate around on this kind of swap?
>

Re: 3/8" Flipping the air cooled front mount. Looks nearly impossible
to my eye. You would end up clearancing too much metal likely making
it weak. Not even sure if mount would fit flipped. I believe both the
air cooled and diesel use the same older style transmission

A pice of my air cooled front bracket on left. Look the same?

http://tinyurl.com/yygp363

Is the DV clutch housing shorter than gas housing?

Neil.

-- 
Neil Nicholson '81 VanaJetta 2.0 "Jaco"

http://tubaneil.googlepages.com/

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines