At 02:47 PM 5/21/2010, Jim Felder wrote:
>Roughly 23mm x 64.5mm with a 15mm hole. Easy enough to take a fender washer
>and a long allthread that will fit into the threads in your slide puller.
>put the allthread through the hole and the washer (on the far end of the
>wrist pin) and thread on the bolt.

What do people do for a reamer if it's necessary to clean off a burr
(Bentley 13.47)?  I could see making one, but that's pretty tough
without a lathe.

Yrs,
d