Just use a triangular machinists scraper and you can peel the burr right
off.

Jim

On Fri, May 21, 2010 at 1:56 PM, David Beierl <dbeierl@attglobal.net> wrote:

> At 02:47 PM 5/21/2010, Jim Felder wrote:
>
>> Roughly 23mm x 64.5mm with a 15mm hole. Easy enough to take a fender
>> washer
>> and a long allthread that will fit into the threads in your slide puller.
>> put the allthread through the hole and the washer (on the far end of the
>> wrist pin) and thread on the bolt.
>>
>
> What do people do for a reamer if it's necessary to clean off a burr
> (Bentley 13.47)?  I could see making one, but that's pretty tough without a
> lathe.
>
> Yrs,
> d
>