

| Subject: | Re: Mice prevention, was : Heater knee bar cross beam |
| From: | John Reynolds |
| Date: | Wed, 16 Jun 2010 09:16:47 -0700 |
I'm down on poison, we have dogs & chickens running around. But I'll have to keep traps going. � My mouse plan is as follows; ( 1st two done years ago) Mesh over battery vent holes Plugged holes behind driver side headlight Block off openings around intake grill ( behind upper grill) Plug knee bar tunnel Wire mesh inside all tubes leading to heater box Wire mesh behind B �pillar vents in door jambs Install mouse neutron bomb trap Last, but not least keep traps when camping. Believe me,I think they get in right through the door jambs. � On running 100 miles a month, not here where salt is used nov thru april,even May! John� LiMBO Reply-To: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>I've posted this many times. All I *ever* do, with excellent results, is get those small yellow triangular boxes of mouse poison at the grocery store .. and put them in places like under work benches in sheds, behind refrigerators .. and if I had a van sitting for a long time... in a few corners here and there. I have never had anything but 'you never see them again' with this method. Been doing it 25 yrs or so. it's also really important to air out sitting vehicles of course, don't leave them under trees, and so forth. 'not using them' is just plane bad for them. Even driving an old vehicle 100 miles a month is not enough to keep it healthy. Can't say enough how important ventilation is. I've got a van in my shop here now, it will take months for the mold smell to get out of it, and I've got it sitting indoors in a dry climate with all windows and doors open. Incense helps, both smell wise and spiritually, for these super fine irreplaceable vans ! on all my outside vehicles, some dozen or so, on nice days ....at least half of them get opened up and aired out. Including, and especially, trunks on sedans. So easy to care for and preserve actually.
Have something to add on this topic today? Revive this thread in the forum »