Yes i did as it stated in my question to the list ;)

Thank you,
Jay Lefstein.
Sent from my mobile device.

On Jul 16, 2010, at 3:02 PM, Steven Johnson <sjohnso2000@GMAIL.COM> wrote:

> Well..... did you remember to put the ignition in the "on" position?
>
> And did you slide the cruise control switch to it's respective on positon?
>
> lt won't light if the above 2 items are not done.
>
> Steven
>
> On Fri, Jul 16, 2010 at 2:25 PM, Jay lefstein <jleftbrane@gmail.com> wrote:
>
>> hello vanadudes... I have just installed cruise control on my 1984
>> westy with a bostig conversion.. i used components from a 1990 carat.
>>
>> drove around the block and tried it a few times and it is not working :
>> (..
>>
>> opened up the bently page section 27.29 and started trouble shooting.
>>
>> it passed the first 2 tests... on test #3 the vacume vent valves. it
>> says to conect  the test light between 1 and 3 of the harness
>> connector. at this point with the ignition and cruise to on position
>> my test light should light up and once i press the brake and clutch
>> the light should go out, if so it passes.... well the proble is i
>> don't get a light.. and it doesn't say what to do in this situation...
>>
>> anybody have a suggestion?
>>
>> don't worry i tested the test light and it is working flawlessly
>>
>> thanks
>> Jay
>>