If you bear down and search for some 16 x 7 steel Mercedes wheels you won't
have to cut and drill and grind and bore...you'll just bolt them on and
drive away.  ;)

YMMV

Jake

On Thu, Jul 15, 2010 at 8:16 PM, Shawn Wright <vwdiesels@gmail.com> wrote:

> Ok, so I got some EV wheels, 15x6 ET55, which appears to be off a '96+ EV.
> Offset is worse than the earlier ones which are either ET51 or ET45, but
> the
> price was right. I think 12mm spacer at the front will do (I got 2x1/4"
> with
> wheels); the rear fit fine on their own with the drum retaining bolts
> removed. The design of the wheel allows 2 threads of the rear nuts to show,
> so about 5-10mm longer studs are needed. At the front, with 12mm spacers
> plus another 5-6mm for thicker wheel seat area means at least 15mm or 20mm
> longer bolts.
>
> For the centre bore, wheels are 57mm, and I need at least 60mm to clear
> front hub. I've ground the lip off one bearing cap to be flush with the hub
> diameter, so only need 1.5mm or so off the wheels.
>
> Is this something a dealer might have if I have the right part #? Or the
> wrecker? (does the EV use bolts or studs?) Or a list vendor that can get
> them to me in Victoria within a few days?
>
>
> --
> Shawn Wright
> '88 Westy TD
>

--
Jake

1984 Vanagon GL 1.9 WBX 'The Grey Van'
1986 Westy Weekender/2.5 SOHC Suby 'Dixie'

Crescent Beach, BC

www.thebassspa.com
www.crescentbeachguitar.com
http://subyjake.googlepages.com/mydixiedarlin%27