A lot nicer than mine, and mine work fine.

Karl

|-----Original Message-----
|From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
|neil n
|Sent: Friday, August 20, 2010 3:30 PM
|To: vanagon@GERRY.VANAGON.COM
|Subject: Propane Expert Eye Needed: Supply Line To Dometic Fridge (pics)
|
|Hi all.
|
|Do any of these bends look like the tube is collapsed too much?
|
|4 pics:
|http://picasaweb.google.com/musomuso/LPLineToFridge#5507616970663334274
|
|It feels somewhat flat at outer side of bends and somewhat ovaled at sides.
|
|This work was done by a licensed RV shop.
|
|I realize it's hard to tell via pics online, but IF bends poorly done,
|would they constrict flow of propane enough to affect flame size?
|
|I swear. I could have done a better job. Heck. I made a coil out of
|soft copper. Granted no 90* bends, but no flat spots save for where it
|was tweaked w/o spring. It looked nicer before I started uncoiling it.
|
|pic:  http://tinyurl.com/2uhjtv6
|
|Thanks!
|
|Neil.
|
|
|
|
|--
|Neil Nicholson '81 VanaJetta 2.0 "Jaco"
|
|http://tubaneil.googlepages.com/
|
|http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-
|engines