Yep, drove Zeno over the pass to the office today specifically so I could
test all that at speed.  There is one added hole for the installation, its
about 2/3rds of the way down the right D-post and sealed.  The lead from the
panel into the D-post is strapped to the backside of the rear support.  So
far I haven't heard anything that resembles chatter; I'm certainly listening
for it to occur.  Zip ties at the ready.

The wind farm is an excellent place to get a good idea of how things will
perform in the wind.  Plus it makes Zeno look pretty.

MT

-----Original Message-----
From: Janne Ruohom�ki [mailto:janne.ruohomaki@gmail.com] 
Sent: Monday, August 16, 2010 11:36 AM
To: Matt Thyer
Cc: vanagon@gerry.vanagon.com
Subject: Re: Aux Power DIY Installation

On Mon, Aug 16, 2010 at 8:26 PM, Matt Thyer <matt_thyer@hotmail.com> wrote:
> Howdy Folks,
> Just wanted to pass along my axillary power system installation which 
> I more or less completed this weekend. �Right now Zeno is parked in 
> the sunshine soaking up the rays.
>
> http://www.flickr.com/photos/sanityfactory/4895991631/in/set-721576231
> 25604343

 No extra holes to the van in this installation ? Be sure that the wiring
going outside of the van does not wobble or vibrate or sound like "BRRRRR"
in the amazingly fast airflow Your van creates if You happen to engage warp
7 when going downhill against the wind. Might cause blockage or leakage of
electrons. Looks stiff and tight enough.

 And this 3MW wind mill that You have on left rear part of Your Vanagons
roof folds in exactly how ?