As you can see, it is obvious that the holes are for bolts or screws to hold
up the heat shield/splash guard.  In this case, they are 6mm bolts.  But
most of the time, those little nuts that were fixed in the body, are
spinning around and the bolts won't help.  I have seen extra holes drilled
for screws to do the same.
Zoltan

----- Original Message -----
From: "Gregory Smith" <gfs@GREGORYFSMITH.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Thursday, September 02, 2010 7:02 PM
Subject: rear valence trim?

While under the van recently replacing my O2 sensor, I noticed four
factory holes in the bottom edge of the rear valence.  Is there a
super-rare, super expensive trim or other piece that fits the holes?
Just kinda wondering...

Gregory Smith
'88 Vanagon GL

Smith Design Studio
Small Building Company
Olympia, WA
360-239-0429
gregoryfsmith.com

--------------------------------------------------------------------------------

No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.851 / Virus Database: 271.1.1/3110 - Release Date: 09/02/10
11:50:00