

| Subject: | Re: Overheat lamp |
| From: | John Rodgers |
| Date: | Thu, 14 Oct 2010 18:33:10 -0500 |
Rob, I can't answer your question, but I'm having the same problem with the coolant level light in the instrument panel not going off after start - for the most part. On a very cold start - like it sat all night - the coolant level light will go out, but if the engine has been started once, or has the least bit of heat from running for a few minutes - or even a hard run for a while - when started again - the light will not go off. I'm open to ideas on this. John John Rodgers Clayartist and Moldmaker 88'GL VW Bus Driver Chelsea, AL Http://www.moldhaus.com On 10/14/2010 6:03 PM, Rob Rubin wrote: > First off when I go to the Vanagon site I cannot seem to find the forums > link!? > > > > I am having an issue where the overheat/low water lamp stays lit after > starting the van. I need to tell you guys I have a Subaru engine in it. The > odd thing is if I turn the engine off and on, off and on, until it "slow" > starts, then the light will go off.Kinda odd huh? I believe but am not sure > that since the Subaru engine has its own dedicated Water temp gauge that I > can rule out any hockus pokus there. The sensor in the reservoir and those > leads are being replaced to make sure they are sound and I will see if the > problem continues. But short of waiting for that I thought I would put it > out there to you folks. > > > > Any Ideas? > > > > Rob > >
Have something to add on this topic today? Revive this thread in the forum »