

| Subject: | How not to unstick a frozen slider. |
| From: | Don Hanson |
| Date: | Tue, 23 Nov 2010 11:42:23 -0800 |
Pacific Northwest, east slope of the mountains. It snowed, warm and wet, yesterday. Today it is clear and cold, in the low 20s and every entry into my van was frozen shut...Couldn't get in any door, tugging and pulling to no avail. I finally got the driver's door open and crawled in. I could see the latch for the slider had worked, the front was cracked open just a bit but the rear pivot slider...it was stuck in tight... So I turned around backwards and gave it the boot...down near the bottom at the back...Wrong! my foot wentright through the inside panel, that cardboard must have been a little old and brittle....The door didn't open, either. I had to go back outside and use a flat pry bar to break loose the ice... I *love* winter! (not) I guess it is almost time to think about the desert trip again... And I have been wanting to spruce up some of my stock inside panels with some nice wood or something.... Don Hanson
Have something to add on this topic today? Revive this thread in the forum »