

| Subject: | Re: Progressive rough running - until ignition reset |
| From: | John Rodgers |
| Date: | Tue, 28 Dec 2010 00:51:23 -0600 |
The current O2 sensor is a fairly new one, official VW type with shield and factory cable and connector. I think I need to get the 'ol test meter out and check connections and grounds. John John Rodgers Clayartist and Moldmaker 88'GL VW Bus Driver Chelsea, AL Http://www.moldhaus.com On 12/27/2010 5:20 PM, Dennis Haynes wrote: > The O2 sensor ground reference is through the brown wire in the hall sensor (distributor) harness . > > Dennis > > Sent from my Windows Phone > > -----Original Message----- > From: Evan Mac Donald > Sent: Monday, December 27, 2010 4:34 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Re: Progressive rough running - until ignition reset > > > >> There is a ground that isn't. It ismost likely at the ECU. >> >> >> >> >> ________________________________ >> From: John Rodgers<inua@CHARTER.NET> >> To: vanagon@GERRY.VANAGON.COM >> Sent: Mon, December 27, 2010 3:46:25 PM >> Subject: Progressive rough running - until ignition reset >> >> Volks, >> >> I have a general Vanagon troubleshooting question - today driving home >> from an enjoyable Christmas gathering with all my family, the van >> engine started twitching - a little skip at first, then as the miles >> rolled it got worse and worse. I was sweating getting home in all that >> snow and rain and raw weather we were having, and sure as heck didn't >> want to stall out and spend time on the side of the road in that >> weather. I managed to make it off I-65 at the southern exit onto Shelby >> Co 25 on towards Columbiana. By the time I got to the last hill just >> outside town - I was down to about 10 miles an hour, and coasted down >> that hill into town to the main stoplight. The plan was to go through >> the light on green, and pull over in a BigBox store parking lot. Didn't >> get the chance. Light changed, and the engine stalled. I turned off the >> wipers, the heater fans, and the head lights, shut off the ignition, and >> then hit the switch again. She fired right up, purring like a kitten. No >> more trouble......... until well up the road. Same thing over again. >> Just a little twitchy at first, then got progressively rough. This time, >> while coasting, I turned the switch off, and back on. The engine cleared >> it throat, and purred like a kitten. Did it twice more before I got home. >> >> So - what could be happening that turning the ignition off and back on, >> results in temporary clearing the problems. At first I thought fuel, >> then some king of ignition trouble, then an electrical fault for sure. >> Electronics somehow. >> >> Any ideas?? >> >> Thanks, >> >> John >> >> -- >> John Rodgers >> Clayartist and Moldmaker >> 88'GL VW Bus Driver >> Chelsea, AL >> Http://www.moldhaus.com >> >
Have something to add on this topic today? Revive this thread in the forum »