At 09:02 AM 5/31/2011, John Lauterbach wrote:
>Where do I buy or how do I make the Tee between the warm up (auxiliary)
>air regulator and manifold the small connection had a restrictor in it

A #54 drill will give you the correct size hole.  Drill almost
completely through with a larger drill, then go from the other end
with the #54.  I can make you one in brass if you need - pmail me.

The restrictor up at the throttle body is harder - the hole is only
.006, half the size of a #80 drill.  To make that at home I think
would involve molding epoxy around a .006 wire.  But it's still
available - 025 129 420.

These numbers are According To Bentley.

Yrs,
d