The problem occurs every morning. Prior to starting this morning I
unplugged the connector from the ECU and measured the sensor resistance.
Then plugged it back into the ECU, made my post about the measurement,
went outside, started the van -- it started poorly then figured it out,
ran my errands, and came back. It will start fine the rest of the day.

On Mon, 2011-06-06 at 12:27 -0700, mark drillock wrote:

> Also, when the problem occurs again test at the ECU pins without
> disturbing the sensor or it's wires. It is what the ECU sees that really
> matters, not just what the sender does. Even if the sender itself is
> working properly it doesn't mean the ECU will see it right.
>
> Mark
>
>
>
> Rob wrote:
> > That's 55 degrees F, that's cold and you know it starts well when
> > cold, drive it & warm it up to when you have the start problem and
> > test it then.
> >
> > Rob
> > becida@comcast.net
> >
> > At 6/6/2011 10:50 AM,Rocket J Squirrel wrote:
> >> Reads 3.4K ohm @ 13 degrees C, which is smack dab in the middle of the
> >> expected correct reading per figure on Bentley page 24.19.
> >>
> >> So I must look elsewhere for cause of trouble.
> >>
> >> O