Make sure you are not measuring from the hot or power side of the relay
coil. If you are then you are measuring the relay coil resistance.

You should read 0 or very close to 0 ohms across any ground. Any resistance,
even 1 ohm is trouble.

Thanks, Tom Hargrave
www.stir-plate.com
www.towercooler.com
www.kegkits.com

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Gus Cairo
Sent: Sunday, July 17, 2011 10:44 AM
To: vanagon@gerry.vanagon.com
Subject: ground wire ohms

On an 1982 aircooled Calif Specs checking the ohms� on the ground wire from
the block� through the harness to the fuel pump double relay, I get a
reading of 9.67 ohms is that correct or is there problems with that wire
Thanks Gus
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1382 / Virus Database: 1516/3770 - Release Date: 07/17/11