

| Subject: | Re: clamps for cv boots, ridged washers for cv bolts |
| From: | Alistair Bell |
| Date: | Wed, 31 Aug 2011 14:13:39 -0700 |
yeah, you're right. my only excuse is lack of sleep. I guess I was thinking of raised suspension via spacers/springs etc. alistair On 2011-08-31, at 1:58 PM, Mike S wrote: > At 04:07 PM 8/31/2011, Alistair Bell wrote... >> if non stock tire/wheel size increases the "resting angle" of the cv >> joints over the stock set up, then the boots will be flexed more >> during everyday driving. > > How would changing the wheel/tire size change the angle, which is > dependent only on the amount of sprung weight (all else being > constant)? i.e. a larger diameter tire would end up raising not only > the wheel hub, but the whole vehicle. > > Beyond that, tire/wheels size changes are almost always done so that > the rolling radius stays very close to stock. So - not even a change in > how far the hub center is from the ground.
Have something to add on this topic today? Revive this thread in the forum »