Was the new harness repaired? (e.g. old sections of wire replaced)  If
so......

Did the engine initially run well, new harness installed?  If so....

I would check any repaired section of wires that might have come loose or
are partially connected. Especially if harness not fully mounted yet.

Neil.

On Sat, Sep 3, 2011 at 1:26 PM, John Rodgers <inua@charter.net> wrote:

> New wiring harness installed in engine bay. After a few moments of
> fiddling - it sounded really good.  Today it sounds like - you know -
> starts with a C!
>
> Engine fires right up, then settles into an idle that is "ok" but not
> wonderful - I can hear an intermittant misfire. Then it begins to run
> more and more and more ragged until it quits with a wheeze. Tried
> re-adjusting the idle - NADA!   I have checked and rechecked for vacuum
> leaks, loose wires, etc. Nothing. I'm at a loss.
>
> Any ideas?
>
> Thanks.
>
> John
>
> --
> John Rodgers
> Clayartist and Moldmaker
> 88'GL VW Bus Driver
> Chelsea, AL
> Http://www.moldhaus.com
>

--
Neil n

65 kb image Myford Ready For Assembly  http://tinyurl.com/64sx4rp

'81 VanaJetta 2.0 "Jaco"  http://tubaneil.googlepages.com/

Vanagon VAG Gas I4/VR Swap Google Group:

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines