On my project syncro,
I found while driving the other day that the drivers side front windshield
wiper was slipping on the shaft but not to badly. Today I investigated. I
took the nut and lock washer off to find that there are no splines left on
the shaft. Bummer. I figured I could just tighten up the nut and be good to
go for a while at least right?
Well in tightening the nut, I found the threads to be stripped..... it won't
tighten at all.

As it stands I no longer have a drivers side windshield wiper. I presume
this job requires removal of the dash right?
I was hoping not to have to do that until winter. Can it be done without
dash removal?
How bad of an idea is it to JB weld the thing on there..... for now?

-Craig