

| Subject: | Re: Failure to Start - 91 Carat |
| From: | John Rodgers |
| Date: | Sun, 25 Sep 2011 17:05:32 -0500 |
Thanks. I'll try this again on Monday. John John Rodgers Clayartist and Moldmaker 88'GL VW Bus Driver Chelsea, AL Http://www.moldhaus.com On 9/25/2011 9:34 AM, Dennis Haynes wrote: > When the engine dies are the warning lights on the dash still lighted? If > not most likely bad ignition switch. > If yes then you need to find out if you had loss of spark or loss of fuel. > Check the boot is properly connected to the throttle body and air flow > meter. > Check the air stabilizer and crankcase breather hoses. > If losing spark look wiring or an ECU problem. > > Dennis > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of > John Rodgers > Sent: Saturday, September 24, 2011 10:29 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Failure to Start - 91 Carat > > Parked my Carat two weeks ago - running oh so fine. Nothing has been done to > it in the interim. It has just sat idle. Didn't need to start it until today > - and it won't. I would appreciate some pointers on how to get this baby to > go. Here is the situation. > > Battery fully charged > Gas tank half full/empty > Fuel under pressure to both fuel rails > All four injectors relatively recently serviced by Cruzin Services Hot spark > - all spark plugs > > Ignition on > Fuel pump runs > Starter engages > Engine turns > Ignition fires > Engine kicks over as in a good start - then immediately dies - like no fuel. > > It behaves as if there is a charge of fuel initially, then it's cut off. > Like the engine starts, burns out the charge, then there's no more fuel. > Much like with a carbureted engine that is fuel starved. > Accelerator pump charges the engine, the engine starts, then quickly dies. > > I disconnected the O2 sensor and the Idle Stabilizer - just to reduce any > negative possibilities there - and tried it - same result. > > I'm at a loss, my good mechanic buddy is at a loss. Are we over looking the > obvious? I have not pulled the injectors to check the spray pattern, but > didn't feel it necessary since they were recently serviced. > > Any input on this problem would be appreciated. > > Thanks > > John > > -- > John Rodgers > Clayartist and Moldmaker > 88'GL VW Bus Driver > Chelsea, AL > Http://www.moldhaus.com > > >
Have something to add on this topic today? Revive this thread in the forum »