Done that. I even went as far as soldering a one tenth Ohm ,15 watt resistor
to the burnt fuse. Multiplied voltage dropped across it by ten to arrive at
current through it.

This gadget is ten times nicer than that.
Ken

----- Original Message -----
From: "Alistair Bell" <albell@SHAW.CA>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, November 06, 2011 10:03 PM
Subject: [VANAGON] Circuit tester, was Re: D15 connector revealed

Or, if you are cheap, err frugal, like me you can use a burned out fuse and
a multimeter. Littlefuse brand blade fuses have exposed contacts at the
exposed head of the fuse that you can get at with needle probes. Or if you
like, trim away more of the plastic at that end and solder on some leads.
Both work well enough for occasional use.

alistair

On 2011-11-06, at 6:03 PM, Loren Busch wrote:

> On Sat, Nov 5, 2011 at 7:39 AM, Kenneth Lewis
> <kdlewis@northstate.net>wrote:
>
>> Picked this up at Harbor Freight
>>
>> http://www.harborfreight.com/20-amp-automotive-fuse-circuit-tester-67725.html
>> I have found it to be helpful working on this kind of problem.
>> Ken
>>
>
> That looks like the perfect tool for tracking down battery draw when
> everything is supposed to be off.  I'm getting one.
>
>>
>>
>>
>>