

| Subject: | Re: End of saga? -- Back home with '84 with rebuilt head |
| From: | Roger Whittaker |
| Date: | Sat, 10 Dec 2011 22:36:17 -0800 |
Dear felt pad the tune up kit sold for the FORD 6 series farm tractor always came with a little pouch or vile of oil for the pad regards On Sat, Dec 10, 2011 at 12:09 AM, Scott Daniel - Turbovans < scottdaniel@turbovans.com> wrote: > throttle switch making contact at idle. > > my what I see .. > about 70 % of vanagons have that feature not working.. > at least half of the ones I see. > and people who do 'tune ups' ..... > I sure don't get the impression that they know to check for that very > important input. > > many vans have their timing too advanced too , a little is ok, but > significantly too advanced timing is not right. > > also ..here's one for you .. > I swear ........I mean .REALLY ....... > I can't possibly be the only vanagon tech in North American that knows why > there is a felt pad under the rotor on the distributor in a 1.9 Digijet > vanagon engine .. > but .. > of the many dozens, even hundreds of vanagons I see full time.. > I have yet to see one of those felt pads oiled .. > even on multi-thousand dollar rebuilt engine installations. > > it's there to lube the centrifugal advance mechanism. > a few drops of fine oil. > it is a service item . > like once a year say. don't overdo it ..just a few drops. > > and ..'tune up' wise .. > Bosch tune up parts barely wear .. > it's not usually anything to do with cap, rotor, plugs, wires ..( poor > running ) > they can of course get old and even fail... > but 95 % of the time ..........they're pretty good and working nicely. > Non-Bosch parts I usually just replace. > Spark plugs can be NGK or whatever ..just so they are gapped right .. > and here's another nit-pick. > I swear I must be the only tech in North American that knows that spark > plugs are not installed in any engine with bone dry threads. Some > anti -seize is right. > > it's in the workmanship .. > it's not in the parts. > Most vanagon weirdness can be fixed with fine tuning, adjustments, cleaning > etc.. > that's not to say parts don't get tired ..they do .. > but 'putting in the parts' is only incidental to ACTUALLY fine tuning and > sorting out a vanagon engine to run right. > I've had some take a while to get fully sorted out for sure. > > one part I have seen be very intermittent for starting is the Idle > Stabilizer . > Fortunately they are available new from Van Cafe .. > and I prefer to have that part in the circuit .. > it will run with it bypassed. > > don't forget to check for vacuum leaks. > I have seen up to 10 on one engine from throttle body to plenum, to intake > runners... > even the screws that hold the fuel pressure regulator on. > > oddly ..one 84 Westy I take care of .. > I found quite a lot of water in the gas ..water and junk, and the fuel tank > is only 5 months old. > > Scott > www.turbovans.com > > > ----- Original Message ----- > From: "John Lauterbach" <jhlauterbach@BELLSOUTH.NET> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Friday, December 09, 2011 9:10 PM > Subject: End of saga? -- Back home with '84 with rebuilt head > > > Van is back in it home garage. >> >> VW Service by Ron in Daytona Beach finished repairs on Wednesday and I >> picked up van yesterday and drove it back to Macon last night. Sometime >> on trip back, the O2-sensor stopped working and I had problems keeping >> the van from stalling when I was at a traffic light. Also, black soot >> had come back on end of tailpipe and exhaust at idle had gasoline smell. >> >> This morning, I disconnected wire O2-sensor and idle smoothed out. >> O2-sensor (Bosch) was less than two months old. >> >> Idle is still not as smooth as it should be and engine has different >> sound than it did before. >> >> I plan on checking the timing and engine vacuum over this weekend. >> >> Anything else I should check? >> >> John >> > -- roger w From Proverbs: Under three things the earth trembles, under four it cannot bear up: a servant who becomes king ... ---------------------------------------------------------- Explore printed work at: http://www.prliving.ca/ View the growing list of video work at: http://www.youtube.com/user/LastonLastof#g/u http://www.prpeak.com/articles/2010/11/29/multimedia/video/doc4c62e5f80d228504902172.txt
Have something to add on this topic today? Revive this thread in the forum »