Sounds like you've done a great job. �The only word of caution i would
add is to ensure that any weep holes located at the bottom of your
door/pillar cavities are left open after your undercoating to ensure
that water doesn't collect and rust start.
I chose fatmat for lining the interior skin of my vans doors, panels,
and floor, and have appreciated the difference in interior sound.
I've just finished reskinning my door panels (driver/passenger/slider)
and went with a bit thicker foam under the new vinyl and notice some
sound reduction from that as well.
The only part of my 91 multivan that i've not insulated with mat is
the front cabin headliner area and the part of the nose that is up
behind the dash. �I notice a lot of wind noise from those areas and
someday may get ambitious and apply there too.
Have some pics of the process out at
www.weidefamily.net/vanagon
Interior > Insulation

all the best,
brent

On Fri, Apr 6, 2012 at 2:09 AM, ralph meyermann
<ralphmeyermann@gmail.com> wrote:
> Not yet,but will shortly. It definitely sounds better than before just
> tapping ot shutting rear hatch and slider due to no panels or insulation at
> all!! Im thinking of some of that sound deadening mat stuff or 1/2" thick
> rubber mat to go over the top of engine compartment and down under rear
> seat/bed
>
> Velma 82diesel 1.6 na westy
>
> On Apr 5, 2012 9:39 PM, "James Felder" <jim.felder@gmail.com> wrote:
>
> So, have you road-tested this yet? I'm curious. Thinking about doing the
> same thing.
>
> Him
>
>
>
>
> On Apr 5, 2012, at 8:36 PM, ralph meyermann <ralphmeyermann@GMAIL.COM>
> wrote:
>
>> Just spent this ...

--
Brent Weide
Portland, Oregon
www.weidefamily.net/vanagon/

-- 
Brent Weide
Portland, Oregon
www.weidefamily.net/vanagon/