<DIV style="FONT-FAMILY: Arial; COLOR: #000000; FONT-SIZE: 24px"><DIV><FONT size=3 face=Tahoma>Hi Volks;</FONT></DIV><DIV><FONT size=3 face=Tahoma>No replies about my disassembly of the Dometic burner box.&nbsp; I hope that's not because it's so simple it doesn't require a reply.</FONT></DIV><DIV><FONT size=3 face=Tahoma>Anyway, I put the body of my post&nbsp; below.</FONT></DIV><DIV><FONT size=3 face=Tahoma>Thanks;</FONT></DIV><DIV><FONT size=3 face=Tahoma>Dave B.</FONT></DIV><DIV><FONT size=3 face=Tahoma></FONT>&nbsp;</DIV><DIV><FONT size=3 face=Tahoma></FONT><DIV><FONT size=3 face=Tahoma>"I pulled the fridge out of my pool cabana (the first Vanagon Westy I owned) as I prepare it for a spare. While doing the maintainence, using past experience and Frank Condelli's write-up, I ran into a snag that I don't remember from the last time. Frank says to remove a screw from the side of the burner box to remove the sparker (after burner propane supply disconnected) and 6 screws to release the base of the burner box. Well, I have an L shaped base, 7 base screws and a different (machine) screw under a small copper line going to the sparker ground (I think). Going through this part of the base is also the wire to the piezo electric sparker (as well as the aforementioned supply line). Both the small line and the wire are held in by red gaskets, I could see a split in one, and I don't know if I should break those seals. I could swear I had that base completely off the last time. Can someone tell me what I'm looking at?" </FONT></DIV><DIV><FONT size=3 face=Tahoma></FONT>&nbsp;</DIV><DIV><FONT size=3 face=Tahoma>Just realized I didn't sign it.&nbsp; That must be the problem.</FONT></DIV><DIV><FONT size=3 face=Tahoma></FONT>&nbsp;</DIV><DIV><FONT size=3 face=Tahoma>Dave</FONT></DIV><BR>&nbsp;</DIV><DIV><FONT size=3 face=Tahoma></FONT>&nbsp;</DIV></DIV>